Had the sti remapped by Duncan/racedynamix at Rowleys garage at Cullompton yesterday (31st) 341/401. Sounds great, pulls like a train, very pleased, thanks Duncan once again! Mick .

401? What set up do you have or is that a mis-print? Seems like a f@ck load of torque. Tell me your secret

Well, I think you,re right, it does seem a lot, but that,s what it is. If Duncan comes on he,ll comfirm it, in the meantime I,ll take a pic of the grath and try to get it up.

Marky dont forget its a hawk sti 2.5l so they do produce shit loads of torque

Ah....... didn't know that it was a 2.5, the avatar says nout m8. It is rarely that we see 2.5 maps on this site so forgive me for asking

I have never seen figures like that for a 2.0 or even a stroker. You just don't get it on a 2.0 car. 60hp torque over hp i have never seen but like i said didn't realise it was a 2.5. If correct it's very impressive and goes a long way to reduce many peoples fears on the reliability of the 2.5 lump.

Nice results fella...

Yeah was making some great torque there.

Was good Mick - sorry it took a while on there - was keen to get it right for you but the heat on the dyno was an issue. Feels rapid on the road

Running a stock clutch Dunc?

DSCF0188

DSCF0188

can't get the picture to come up just the code.

Use photo bucket or the like m8, i have to get the missus to do it usually


Really impressed with those torque figures, must really pull

Upload the picture to www.photobucket.com

Then copy and paste the "IMG Code" to a post on the forum

Like Jay said!! or get the wife to do it

I am getting the wife to do it, she,s not very good and I,m hopeless! I,ll have to get some advice on where I,m going wrong.